CCNA, CCNP, MCSA, CCNA Final Exam, All Answer Test Module With 100/100

There are two version CCNA Semester 2 chapter 5 hope they can help you get 100/100. good luck! You can download here Version 1 =>   Version 2 =>  

Chapter 5 With 100% Accurate Answers 1. In what two ways does SDM differ from the IOS CLI? (Choose two.) **SDM is used for in-band management only. The IOS CLI can be used for in-band and out-of-band management. SDM is accessed through a Telnet application. The IOS CLI is accessed through a web browser. SDM is available for all router platforms. The IOS CLI is available for a limited number of Cisco devices. **SDM utilizes GUI buttons and text boxes. The IOS CLI requires the use of text-based commands. SDM is used for advanced configuration tasks. The IOS CLI is preferred for initial basic device configuration. 2. Which mode will a configured router display at login? global configuration mode setup mode ROM monitor mode **user EXEC mode 3. Refer to the exhibit. Which password or passwords will be encrypted as a result of the configuration that is shown? virtual terminal only enable mode only console and virtual terminal only enable mode and virtual terminal only the service password **

1. Refer to the exhibit. All routers in the exhibit are running RIP v1. The network administrator issues the show ip route command on router A. What routes would appear in the routing table output if the network is converged? (Choose two).   R 192.168.2.0/24 [120/1]   R 10.10.1.0/24 [120/2] 2. Refer to the exhibit. The Ethernet interface on Router2 goes down and the administrator notices that the route is still valid in the routing table of Router1. How much longer will it take for Router1 to mark the route invalid by setting the metric to 16?   155 seconds 3. Refer to the exhibit. The network that is shown is running RIPv1. The 192.168.10.0/24 network was recently added and will only contain end users. What command or set of commands should be entered on Router1 to prevent RIPv1 updates from being sent to the end user devices on the new network while still allowing this new network to be advertised to other routers?   Router1(config-router)# passive-interface fastethernet 0/0 4. Which

CCNA 2 - Module 5 Refer to the exhibit. The network that is shown is running RIPv1. The 192.168.10.0/24 network was recently added and will only contain end users. What command or set of commands should be entered on Router1 to prevent RIPv1 updates from being sent to the end user devices on the new network while still allowing this new network to be advertised to other routers? Router1(config-router)# passive-interface fastethernet 0/0 The following line was displayed in the output of the show ip route command. R 192.168.3.0/24 [120/3] via 192.168.2.2, 00:00:30, Serial0/0 What is the value of the routing metric? 3 Which of the following is considered a limitation of RIP v1? RIP v1 does not send subnet mask information in its updates. Refer to the exhibit. The Ethernet interface on Router2 goes down and the administrator notices that the route is still in the Router1 routing table. How much longer will Router1 keep the down network in its routing table before marking it as possibly do