CCNA, CCNP, MCSA, CCNA Final Exam, All Answer Test Module With 100/100

CCNA Certification The Cisco CCNA network associate certification validates the ability to install, configure, operate, and troubleshoot medium-size routed and switched networks, including implementation and verification of connections to remote sites in a WAN. This new curriculum includes basic mitigation of security threats, introduction to wireless networking concepts and terminology, and performance-based skills. This new curriculum also includes (but is not limited to) the use of these protocols: IP, Enhanced Interior Gateway Routing Protocol (EIGRP), Serial Line Interface Protocol Frame Relay, Routing Information Protocol Version 2 (RIPv2),VLANs, Ethernet, access control lists (ACLs)     * 1 Console Login     * 2 Router Configuration     * 3 Examine the Router     * 4 Copy to a TFTP server     * 5 Copy from TFTP server     * 6a Clear the backup config     * 6b Saving the ...

1. Refer to the exhibit. A network administrator is trying to configure a router to use SDM. After this configuration shown in the exhibit is applied, the SDM interface of the router is still not accessible. What is the cause of the problem? *The username and password are not configured correctly. The authentication method is not configured correctly. The HTTP timeout policy is not configured correctly. The vtys are not configured correctly. 2. Refer to the exhibit. Branch A has a non-Cisco router that is using IETF encapsulation and Branch B has a Cisco router. After the commands that are shown are entered, R1 and R2 fail to establish the PVC. The R2 LMI is Cisco, and the R1 LMI is ANSI. The LMI is successfully established at both locations. Why is the PVC failing? The PVC to R1 must be point-to-point. LMI types must match on each end of a PVC. The frame relay PVCs cannot be established between Cisco and non-Cisco routers. *The IETF parameter is missing from the frame-relay map ip 10....

CCIE LAP CCNA CCNA - Hotspot Questions CCNA 640-802 VLAN / VTP Practice Questions CCNA 640-802 WAN Practice Questions CCNA Drag and Drop Questions CCNA Exploration 1 - Module 2 Exam Answers Version 4.0 100% CCNA full course including simulators dumps etc CCNA Implementation SIM CCNA lab CCNA Practice Certification Exam # 1 - CCNA Exploration: Accessing the WAN (Version 4.0) CCNA Practice Certification Exam 2 CCNA Practice Tests 3.1.0 CCNA Troubleshooting Questions 1 CCNA Troubleshooting Questions 2 CCNA VOICE Official Guide CCNA WAN Questions CCNA: Cisco Certified Network Associate: Fast Pass CCNP Lab Cisco IOS access lists: 10 things you should know   Cisco Network Magic Pro 5.0.8282 Cisco Press ICND1 2nd Edition Jan 2008 Cisco Training CCNA IP Addressing - Part 1 of 5 CONFIGURING STATIC ROUTING RIP IGRP OSPF ON CISCO ROUTER Ebook.CCNA Security Official Exam Certification Guide Exam 640-553 Exam Certifica.15872...

http://p4s-ccna.blogspot.com http://testccna-4u.blogspot.com 1. Excessive broadcasts are generally a symptom of a problem at which layer?    data link 2. Refer to the exhibit. Users at Branch B are reporting trouble accessing a corporate website running on a server that is located at HQ. HQ and Branch A users can access the website. R3 is able to ping 10.10.10.1 successfully but not 10.10.10.2. The users at Branch B can access servers at Branch A. Which two statements are true aboutthe troubleshooting efforts? (Choose two.)    Frame Relay at R3 and R2 should be tested to narrow the scope of the problem.    An ACL entry error could cause the failure at Layer 4 in either R3 or R2. 3. What is one example of a physical layer problem?    incorrect clock rate 4. Which two components should be taken into consideration when establishing a network baseline? (Choose two.)    information about the network design    expected performance un...

http://p4s-ccna.blogspot.com http://testccna-4u.blogspot.com 1. Refer to the exhibit. IPv6 address 2006:1::1/64 eui-64 has been configured on the router FastEthernet0/0 interface. Which statement accurately describes the EUI-64 identifier configuration? The configuration will derive the interface portion of the IPv6 address from the MAC address of the interface. 2. Refer to the exhibit. Which address or addresses represent the inside global address? 209.165.20.25 3. Your organization is issued the IPv6 prefix of 2001:0000:130F::/48 by your service provider. With this prefix, how many bits are available for your organization to create subnetworks? 16 4. What are two benefits of NAT? (Choose two.) It saves public IP addresses. It adds a degree of privacy and security to a network . 5. What is true regarding the differences between NAT and PAT? PAT uses unique source port numbers to distinguish between translations. http://p4s-ccna.blogspot.com http://testccna-4u.blogspot.com ...

http://p4s-ccna.blogspot.com http://testccna-4u.blogspot.com 1. Which two Layer 1 requirements are outlined in the Data-over-Cable Service Interface Specification (DOCSIS)? (Choose two.) channel widths modulation techniques 2. Which is an example of symmetric-key encryption? pre-shared key 3. Which two statements are valid solutions for a cable ISP to reduce congestion for users? (Choose two.) allocate an additional channel subdivide the network to reduce users on each segment 4. While monitoring traffic on a cable network, a technician notes that data is being transmitted at 38 MHz. Which statement describes the situation observed by the technician? Data is being transmitted from the subscriber to the headend. 5. After conducting research to learn about common remote connection options for teleworkers, a network administrator has decided to implement remote access over broadband to establish VPN connections over the public Internet. What is the result of this solution? The conn...